Últimas versiones - A4900 Vibrio M

Versión 4.81

01.06.2020

• USB-C hardware / firmware optimization

Versión 4.70

27.03.2019

• Envelope FFT range increased to 800 Hz

Versión 4.66

14.02.2018

• All measurements measured under one measurement point has the same time.
• Unification of FASIT with VA3 Pro, VA4 Pro devices

Versión 4.59

22.07.2016

• FASIT – manual speed entry, Adash alarms used for evaluation 
• Internal improvements

Versión 4.55

10.06.2016

• New FASIT bar - the severity level of a different type of fault
• FASIT can be stored into DDS software
• Protection against data loss in case of sudden switch off

Versión 4.50

15.02.2016

• Inverse display possibility in Route mode.
• Used memory indicator in Route menu.
• Unification of the screen names when saving.
• Rows modification (when scrolling through the data).
• Correction of memory deleting

Versión 4.40

19.06.2015

• Temperature measuring in route added.
• The last route measurement can be simply deleted.
• The route measurements counter is be initialized once you delete the memory data.
• Temperature unit repair °C. (° was not visible in the memory instrument).

Versión 4.30

21.11.2014

• ICP Error detection improvement.
• Data browsing up and down is possible.
• Upper part of display is visible during data storing (Storing data are visibled).
• Indication when data are stored.
• Switching measuring units repaired.
• Data in memory are displayed by unit settings.
• Waking of dispaly from sleep improvement.
• Internal code optimalization.

Versión 4.24

20.04.2014

• Unification of ESC function on "UP" button.
• "Are you sure?" question before Clear Data and Clear Memory.
• Data position counter is displayed on "View data" screen.

Versión 4.23

13.03.2014

• First release with "Vibrio M" extension.
• Data storing to Memory and Route enabled.
• Only for instruments with USB interface.